Changing out some multi turn shutoff valves from under my kitchen sink.
Being that they are soldered in, I'm going to cut it a bit below the solder and use some shark bite quarter-inch turn fittings.
But forgot to pick up a Depth guide and a deburring tool (they come as 1 with shark bite.)
Curious if anyone here has one handy in Lakewood, New Jersey for me to borrow?
If not I'll just have to pick one up tomorrow.
was aiming to finish the job tonight that way I don't have to put the valves back on and some new washers.
The part I'm looking for is..
https://www.amazon.com/SharkBite-Deburring-Depth-Copper-U702A/dp/B000K6QFSU/ @CountValentine What would you recommend?
Using a compression fitting? SharkBite fitting ? or standard soldered fitting?